Ricoh AP410 Setup Manual page 81

Installing Options
H
Push the duplex unit securely into the printer.
❒ After finishing installation, you can check the Bluetooth interface unit is
properly installed: Print the configuration page from the "List/Test Print"
menu. If the new device is listed in the column of configuration options,
then it has been properly installed.
❒ If the duplex unit is not installed properly, repeat the procedure from the
start. If you cannot install it properly even after reinstallation, contact your
sales or service representative.
❒ If the printing position is not correct, adjust the registration of the trays. For
more information about adjusting the registration of the trays, see "Adjust-
ing Tray Registration", Maintenance Guide.
For printing the configuration page, see p.33 "Test Printing".
81