Ricoh AP410 Setup Manual page 14

Guide to the Printer
8.
Front Cover Release Button
Use this button to open the front cover.
9.
Power Switch
Use this switch to turn the printer power on and off.
10.
Paper Tray (Tray 1)
Loads up to 500 sheets of plain paper (80 g/m
See "Paper and Other Media Supported by this Printer", Maintenance Guide.
❒ Paper Tray is displayed "Tray 1" on the display.
11.
Friction pad
This is required to feed in paper one sheet at a time. Clean the friction pad when more
than one sheet of paper is fed into the printer. Also, replace the friction pad when the
message "Replace Maintenance Kit", appears.
12.
Paper Tray Cover
This is installed on the back of the printer.
13.
Power Cord
Connect this cord into a wall outlet.
14.
Rear Cover
Remove to install the optional duplex unit or to replace the fusing unit.
15.
Ventilators
These holes help to keep components inside the printer from overheating.
❒ Do not block or obstruct the ventilators. A malfunction may occur due to over-
heating.
16.
Controller Board
• Basic model printer:
Slide it out to install options such as the memory unit, network interface board, 1394
interface unit, 802.11b interface unit, Bluetooth interface unit or printer hard disk.
Plug cables such as the USB cable and parallel interface cable and into their connec-
tors.
• Network standard model printer:
Slide it out to install options such as the memory unit, 1394 interface unit, 802.11b
interface unit, Bluetooth interface unit or printer hard disk.
Plug cables such as the ethernet cable, USB cable and parallel interface cable and
into their connectors.
2
, 20 lb.) into this tray for printing.
14