Table of Contents
Advertisement
52
ST1000 Plus & ST2000 Plus Tiller Pilots
D3270-2
If the display continues to show a flashing 'C' and the current heading, the tiller
pilot is not receiving any wind data. The most likely reason is a cabling error –
either open circuit, short circuit or wires reversed.
Checking the SeaTalk interface
If you have linked the tiller pilot to other instruments or control units via SeaTalk,
check the link as follows:
1. Press standby .
D3271-2
2. Select display illumination level 0 (LAMP 0) on any other SeaTalk instrument
or autopilot control unit.
D170-2
Hide quick links:
Advertisement
Table of Contents
