Table of Contents
Advertisement
40
3. Mark the bolt holes on the mounting ring and then drill three 6 mm (
diameter holes.
4. Bed the mounting ring on a thin coat of silicon sealant.
5. Use three 6 mm (
ing ring to the backing plate (with the backing plate on the other side of the
mounting surface, as shown above).
6. Screw the mounting socket firmly into place.
When the tiller pilot is not in use, you can unscrew the complete rod assembly to
Note:
leave the cockpit unobstructed.
Alternative tiller pins
Your Raymarine dealer can also supply the following alternative lengths of tiller
pin for other non-standard installations.
Description
Small threaded tiller pin
Extra length tiller pin
Extra length threaded tiller pin
4.3 Cabling and socket installation
Both power and data are supplied to the tiller pilot via a waterproof plug and
socket. The plug comes ready assembled and the socket can be mounted in the
cockpit area adjacent to the tiller pilot.
1
/
in) diameter bolts, nuts and washers to attach the mount-
4
+12 V DC (brown, pin 1)
0 V (blue, pin 2)
ST1000 Plus & ST2000 Plus Tiller Pilots
Size
25 mm (1.0 in)
72 mm (2.8 in)
72 mm (2.8 in)
NMEA + (white, pin 6)
NMEA - (green, pin 5)
SeaTalk data (yellow, pin 4)
1
/
in)
4
Part no.
D014
D020
D021
D305-3
Hide quick links:
Advertisement
Table of Contents
