32
'B'
460 mm
(18 in)
To measure the critical dimensions:
1. Clamp the tiller on the boat's center line.
2. Mark dimensions A and B and use masking tape to locate the fixing points.
For standard installations, dimension A is measured on the starboard side of the
Note:
cockpit. If you need to mount the tiller pilot on the port side of the cockpit, you can measure
dimension A to port. However you will need to reverse the tiller pilot's operating sense
when you have completed installation (see page 49).
3. Make sure that:
• dimensions A and B are at right angles to each other (as shown on the
• the tiller pilot is mounted horizontally
589 mm (23.2 in)
610 mm (24.0 in)
diagram opposite)
ST1000 Plus & ST2000 Plus Tiller Pilots
'A'
445 mm (17.5 in)
90˚
Rudder axis
47.5 mm
(1.9 in)
95 mm
(3.7 in)
Sloping rudderstock
D3198-2