34
CAUTION:
As the tiller pilot is capable of generating high pushrod loads, you
MUST:
• drill all holes to the specified size and reinforce where necessary
• allow the epoxy to harden thoroughly before applying a load
Installation accessories
If you are not able to install the tiller pilot directly onto the cockpit seat or tiller as
described, one (or a combination) of the following installation accessories:
• pushrod extensions
• tiller brackets
• cantilever sockets
• pedestal sockets
• alternative tiller pins
Pushrod Extensions
If you need to increase the pushrod length (because of the distance from the
mounting socket location to the center line), use a Raymarine pushrod extension.
Identifying the correct pushrod extension
1. Clamp the tiller on the boat's center line.
2. Measure dimension C.
3. Select the appropriate pushrod extension length (and part number) using the
following table.
Dimension C
589 mm (23.2 in)
615 mm (24.2 in)
640 mm (25.2 in)
665 mm (26.2 in)
691 mm (27.2 in)
716 mm (28.2 in)
742 mm (29.2 in)
ST1000 Plus & ST2000 Plus Tiller Pilots
Pushrod extension length L
Standard dimension
25 mm (1 in)
51 mm (2 in)
76 mm (3 in)
102 mm (4 in)
107 mm (5 in)
152 mm (6 in)
Part no.
-
D003
D004
D005
D006
D007
D008