Typical Stick Welding Connections And Control Settings - Miller Bobcat 260 Diesel Owner's Manual

6-3.

Typical Stick Welding Connections And Control Settings

3/4 in.
wrench
crescent wrench
OM-286506 Page 32
�
Complete Parts List is available at www.MillerWelds.com
Stop engine.
�
This section provides general guide-
lines and may not suit all applications.
�
The control panel shows the typical set-
tings for welding with a 7018 (1/8 in.)
electrode. Consult the amperage se-
lection tables below if welding with oth-
er electrodes.
1 Work Clamp
2 Electrode Holder
3 Electrode Selection Table
Cover)
Connect Work cable to Work terminal and
Electrode holder cable to Electrode terminal
on welder/generator.
�
Be sure to use the correct size weld ca-
bles (see Section 5-6).
Typical Settings For 7018
Electrode:
� Set Weld Process Selector switch to +
Stick position.
� Set Coarse Range switch to 60-160 (1/
8") position.
� Set Fine control at 7 or higher for best
results.
�
Miller recommends Hobart filler metals.
(Beneath
(1/8 in.)