Connecting Weld Output Cables - Miller Bobcat 260 Diesel Owner's Manual

5-8.

Connecting Weld Output Cables

1
3
4
5
3/4 in. (19 mm)
wrench
crescent wrench
nutdriver
chippinghammer
wirecutter
greasegun
filterwrench
OM-249336 Page 26
file
Complete Parts List available at www.MillerWelds.com
�
Complete Parts List is available at www.MillerWelds.com
6
frontcutter
paintbrush
2
Stop engine.
Failure to properly connect weld
cables may cause excessive heat
and start a fire, or damage your
machine.
�
Do not place anything between weld
cable terminal and copper bar. Make
sure that the surfaces of the weld cable
terminal and copper bar are clean.
1 Correct Weld Cable Connection
2 Incorrect Weld Cable Connection
3 Weld Output Terminal
4 Supplied Weld Output Terminal Nut
5 Weld Cable Terminal
6 Copper Bar
Remove supplied nut from weld output termi-
nal. Slide weld cable terminal onto weld out-
put terminal and secure with nut so that weld
cable terminal is tight against copper bar.
OM-286506 Page 29