Miller Bobcat 260 Diesel Owner's Manual page 49

C. Checking Throttle Solenoid
A. Checking Throttle Solenoid
wrench
crescent wrench
nutdriver
chippinghammer
wirecutter frontcutter
filterwrench
file paintbrush
5/32 in.
allen_wrench
3/8, 7/16 in.
wrench
flashlight ruler
pliers
�
Complete Parts List is available at www.MillerWelds.com
1 2 3
7
allen_set
crescent wrench
needlenose
5
4
6
5/8 in.
(16 mm)
259852-A
tools/
flathead philips head
Stop engine.
If the engine does not stay at idle speed, ver-
ify the throttle solenoid and linkage is in-
stalled properly.
Adjusting Throttle Solenoid
1 Throttle Solenoid
2 Jam Nut
3 Solenoid Link
4 Shoulder Bolt
5 Throttle Lever
6 Solenoid Rod
7 Throttle Solenoid Mounting Screw
Loosen jam nut, remove shoulder bolt, and
remove link from throttle lever. Install link 5/8
in. (16 mm) on solenoid rod. Reconnect link
to shoulder bolt and throttle lever.
Push solenoid rod into idle (energized) posi-
tion and check for non-binding lateral move-
ment of throttle link at throttle lever. If link
binds, loosen solenoid mounting screws.
Move the solenoid slightly until the link
moves freely with solenoid in deenergized
(relaxed) and energized positions. Tighten
screws.
Tighten jam nut.
Go to Step D.
wrench
crescent wrench
OM-286506 Page 45
OM-258413 Page 21