Miller Bobcat 260 Diesel Owner's Manual page 48

B. Checking Fuel Solenoid Run Position
Top View
Ref. 259852
3/8, 7/16 in.
wrench
crescent wrench
OM-286506 Page 44
OM-258413 Page 20
nutdriver
�
Complete Parts List is available at www.MillerWelds.com
8
1
2
If the engine is low on power or does not
start and stop when using the Engine Control
switch, check the position of the fuel sole-
noid in the Off and Run positions, and check
solenoid movement.
1 Fuel Solenoid Plunger
2 Fuel Solenoid
3 Shutdown Lever
4 Shutdown Lever Vertical Arm
5 Adjustment Screw Housing
6 Fuel Solenoid Jam Nut
7 Block Pin
8 Fuel Solenoid Mounting Screws
Checking Solenoid Run Position
Turn Engine Control switch to the Run posi-
tion. Manually push fuel solenoid plunger in-
to the fuel solenoid body. (This action will
hold the plunger in the Run/energized
6
position.)
7
Verify the vertical arm of the shutdown lever
4
contacts or is within 1/16 in. (1.5 mm) of the
adjustment screw housing. If the shutdown
lever does not contact the housing, loosen
the fuel solenoid jam nut. Turn the fuel sole-
noid plunger to extend the linkage until lever
contacts housing. Tighten jam nut.
Verify fuel solenoid block pin does not disen-
gage from the shutdown lever. If block pin
5
disengages from shutdown lever, loosen the
jam nut and turn the fuel solenoid plunger to
bring the pin closer to the shutdown lever.
Tighten jam nut.
3
Check Solenoid Movement
Turn Engine Control switch to Off position.
Manually move shutdown lever and verify
solenoid plunger and linkage moves freely. If
linkage binds, loosen fuel solenoid mounting
screws and adjust alignment so linkage
moves freely between the engine Run and
Off positions.
Stop engine.