Table of Contents
Advertisement
4-1.
Serial Number And Rating Label Location
The serial number and rating information for this product is located on the back. Use rating label to determine input power requirements and/or
rated output. For future reference, write serial number in space provided on back cover of this manual.
4-2.
Software Licensing Agreement
The End User License Agreement and any third-party notices and terms and conditions pertaining to third-party software can be found at
https://www.millerwelds.com/eula
4-3.
Information About Default Weld Parameters And Settings
NOTICE – Each welding application is unique. Although certain Miller Electric products are designed to determine and default to certain typical
welding parameters and settings based upon specific and relatively limited application variables input by the end user, such default settings are
for reference purposes only; and final weld results can be affected by other variables and application-specific circumstances. The appropriate-
ness of all parameters and settings should be evaluated and modified by the end user as necessary based upon application-specific require-
ments. The end user is solely responsible for selection and coordination of appropriate equipment, adoption or adjustment of default weld
parameters and settings, and ultimate quality and durability of all resultant welds. Miller Electric expressly disclaims any and all implied warran-
ties including any implied warranty of fitness for a particular purpose.
4-4.
Weld, Power, And Engine Specifications
�
This equipment will deliver rated output at an ambient air temperature up to 104°F (40°C).
Weld Output
Welding Mode
Range
CC/AC
40 - 260 A
CC/DC
40 - 260 A
CV/DC
17 - 28 V
4-5.
Environmental Specifications
A. Temperature Specifications
Operating Temperature Range*
–20 to 104°F (–29 to 40°C)
*Output is derated at temperatures above 104°F (40°C).
4-6.
Regulatory Approval
This device complies with Part 15 of the FCC rules. Operation is subject to the following conditions:
1. This device may not cause harmful interference, and
2. This device may accept any interference received, including interference that may cause undesired operation.
WARNING! Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate
this device.
Reception of the fob and receiver signal can be affected by the weather, environment, and/or area conditions.
�
Complete Parts List is available at www.MillerWelds.com
SECTION 4 – SPECIFICATIONS
and are incorporated by reference herein.
Rated Welding
Maximum Open-
Output
Circuit Voltage
260 A, 25 V,
100% Duty Cycle
260 A, 25 V,
100% Duty Cycle
275 A, 25 V, 60%
Duty Cycle
250 A, 28 V,
100% Duty Cycle
Generator Power
Rating
80
80
Peak: 11.0 kVA/kW
Continuous: 9.5 kVA/
kW Single-Phase 80/
40 A, 120/240 VAC 60
41
Hz (while not welding)
Storage/Transportation Temperature Range
–40 to 131°F (–40 to 55°C)
Engine Liquids
Engine
Capacity
Kubota D722
Water-Cooled,
Three-Cylinder
Four-Cycle Die-
sel Engine Pro-
ducing 19 HP @
Fuel: 12 gal (45
3600 RPM
L) Tank
(Weld Speed)
2450 RPM Idle
Oil: 3.4 qt (3.2 L)
Speed
Sound Level At
Rated Output:
79.5dB (105.0
Lwa) @ 7 m
OM-286506 Page 17
Advertisement
Table of Contents
Troubleshooting
