Replacing Air Cleaner; Overload Protection - Miller Bobcat 260 Diesel Owner's Manual

8-3.

Replacing Air Cleaner

259 707
tools/
8-4.

Overload Protection

ear plugs electrodewrench
OM-258413 Page 16
cclamp rpmmeter
hacksaw belttensiongauge
259 707
pencil fusepuller
3/8 in.
wrench
�
Complete Parts List is available at www.MillerWelds.com
1
2
helmet weldshield
benchvise
1
2
3
sealant_1
4
mallet
crescent wrench
faceshield
popriveter
tape
scissors
Stop engine.
NOTICE – Do not run engine without air
cleaner or with dirty element. Engine dam-
age caused by using a damaged element is
not covered by the warranty.
1 Air Intake Tube
2 Hose Clamp
3 Air Cleaner
Loosen hose clamp, slide air cleaner to-
wards rear of unit and remove. Slide new air
cleaner onto intake tube and tighten clamp.
Replace air cleaner every 200 hours or less
if used in severe conditions.
3
Stop engine.
�
When a circuit breaker or fuse opens, it
usually indicates a more serious prob-
lem exists. Contact a Factory Author-
ized Service Agent.
1 Fuse F1
F1 protects the weld excitation winding from
overload. If F1 opens, weld output stops or is
low.
2 Fuse F2
F2 protects the generator power excitation
winding from overload. If F2 opens, genera-
tor power output stops or is low.
3 Circuit Breaker CB7
CB7 protects the engine glow plug circuit. If
CB7 opens, the glow plug will not heat. CB7
automatically resets when the fault is
corrected.
4 Supplementary Protector CB8
CB8 protects the engine battery circuit. If
CB8 opens, the engine will not crank. CB8
automatically resets when the fault is
corrected.
Replace any open fuses. Close door and/or
reinstall cover before operating unit.
OM-286506 Page 41