Typical Stick Welding Connections And Control Settings - Miller Bobcat 250 Diesel Owner's Manual

6-3. Typical Stick Welding Connections And Control Settings

OM-258413 Page 30
.
Complete Parts List is available at www.MillerWelds.com
1
!
Stop engine.
.
This section provides general
guidelines and may not suit all
applications.
Typical Settings For 7018 (1/8 in.)
Electrode:
>
Set Weld Process Selector
switch to + Stick position.
>
Set Coarse Range switch to
60-160 (1/8") position.
>
Set Fine control at 7 or higher
for best results.
.
Consult the amperage selection
tables below if welding with other
electrodes.
1 Work Clamp
2 Electrode Holder
Connect Work cable to Work terminal
and Electrode holder cable to Elec-
trode terminal on welder/generator.
.
Miller recommends Hobart filler
metals.
2
Tools Needed:
3/4 in.
259 707 / Ref 258 070-A