Using Wireless Remote - Miller Bobcat 225 Owner's Manual

6-2.

Using Wireless Remote

2 3
OM-286503 Page 30
�
Complete Parts List is available at www.MillerWelds.com
4
1
Place Engine Control switch in Off
position when welder/generator is
not in use to prevent unexpected
starting.
Check that all doors, panels, cov-
ers, and guards are closed and se-
curely in place before starting.
1 Fob Button
2 Communication LED
3 Cranking LED
4 Running LED
�
Place welder/generator in a location
where remote signal is not blocked dur-
ing operation. If signal is weak, shorten
distance between fob and unit.
�
If welder/generator is out of range of
the fob, the Communication LED will
blink rapidly after completing the start-
ing or shut off sequence.
Starting Sequence
�
Engine Control switch must be in Run
or Run/Idle position for remote starting.
Press and release Fob button. Within two
seconds, press and hold Fob button for three
seconds. The Communication LED is illumi-
nated green while button is held.
After the three-second hold timer expires,
the Communication LED turns Off. The fob
beeps once. Release the button within two
seconds of the Communication LED turning
Off. When the button is released, the start
command is transmitted to the welder/
generator.
If the Cranking LED blinks red and the fob
beeps twice, the transmit was successful
and the startup sequence begins. The alarm
on the welder/generator chimes for up to 10
seconds.
When the engine starts, the Running LED il-
luminates green for two seconds, and the
fob beeps twice. If the engine does not start
after 20 seconds, the Running LED illumi-
nates red for two seconds and the fob emits
one long beep.
Shut Off Sequence
Press and hold Fob button for one second.
The Communication LED is illuminated
green while button is held.
After the hold timer expires, the Communica-
tion LED turns Off. The fob beeps once. Re-
lease the button.
When the engine has stopped, the Running
LED illuminates red for two seconds, and the
fob beeps four times.