Overload Protection - Miller Bobcat 225 Owner's Manual

8-4.

Overload Protection

tools/
ear plugs electrodewrench
cclamp rpmmeter
hacksaw belttensiongauge
pencil fusepuller
3/8 in.
wrench
sealant_2
nutdriver
�
Complete Parts List is available at www.MillerWelds.com
helmet weldshield
benchvise
2
1
sealant_1
mallet
crescent wrench
pump pliers
faceshield
popriveter
tape
scissors
Torx
Stop engine. Disconnect negative
(-) battery cable.
�
Fuses F1 and F2 located on bracket
behind right side panel.
1 Fuse F2
F2 protects the weld excitation winding from
overload. If F2 opens, weld output stops or is
low.
2 Fuse F1
F1 protects the generator power excitation
winding from overload. If F1 opens, genera-
tor power output stops or is low.
3 Fuse F6
F6 protects the engine wiring system from
overload. If F6 opens, engine will not crank.
Replace any open fuses. Reinstall cover be-
fore operating.
�
If a fuse opens, it usually indicates a
more serious problem exists. Contact a
3
Factory Authorized Service Agent.
OM-286503 Page 43