Table of Contents
Advertisement
•
•
•*
Interior temperature (status)
•
•*
Engine temperature (status)
•
•*
Outside sensor (status)
Voltage of the on-board circuits (status, security zone – alarm
•
level)
•
Shock sensor (security zone – alarm and warning level)
•
Motion sensor (security zone – alarm level)
•
Tilt sensor (security zone – alarm level)
OE alarm system status via CAN, additional sensor,
•
•*
(status, security zone – alarm and warning level)
•
•
Turning ignition on (status, security zone – alarm level)
Opening doors, separate indication for each door via CAN
•
•
(status, security zone – alarm level)
•
•
Opening a trunk (status, security zone – alarm level)
•
•
Pressing brake (status, security zone – alarm level)
•
•
Engine operation control - RPM (status)
•
•
Position of a gearbox selector/handbrake(status)
•
"Parking light is not turned off" notification
Control (Commands)
•
•
Central lock
•
Car original alarm system
•
•
Trunk
•
•
Turn lights
•
•
Closing windows
•
•*
Engine pre-heaters
CAN
6
PANDORA MINI V4 CAR SERVICE-SECURITY SYSTEM
Security zones
Arming mode
The arming mode monitors security zones and provides engine blocking. If one
of the security zones is triggered, the system will record this event in its non-
volatile memory, activate the alarm or warning mode and inform an owner
with an indication of the zone. If the system is armed, the engine is running,
and one of the security zones is triggered, the system will stop the engine.
Arming/disarming, alarm mode and warnings are accompanied by sound
and light signals. The system confirms arming with 1 sound signal and 1 flash of
the turn indicators. The system confirms disarming with 2 short sound signals
and 2 flashes of the turn indicators. If one of the security zones is opened, the
system will produce 4 warning sounds and 4 flashes of the turn indicators at
the moment of arming. The system will also produce 4 warning sounds and 4
flashes of the turn indicators at the moment of disarming if there were alarm
events during the armed period. The system activates light and sound signals
for 30 seconds in the alarm mode. The alarm signals can be cancelled by an
arming or disarming command. If a warning zone is triggered, the system will
produce 1 sound signal and 1 flash of the turn indicators.
If one of the security zones fails, the system will forcibly turn off this zone.
If a switch triggers more than 9 times in a row, it will be disabled until the next
arming. The shock/tilt/motion sensor is temporarily deactivated (15 sec.) if it
has been triggered more than 3 times in a row.
Multi-button code immobilizer
Multi-button code immobilizer (pin-to-drive) is a function that allows disarm-
ing, disabling blocking and controlling Service mode and time channels using
original vehicle controls (button, lever or pedal) and a pre-programmed PIN-
code (the "Immobilizer PIN-code"). The function works using special analog
inputs or digital buses of a car.
An example of using the function:
Turn on the ignition to disable engine blocking or Service mode, turning on the
ignition is not required if you want to disarm the system or control time channels.
Enter the "Immobilizer PIN-code". Press a programmed button/lever/pedal
the number of times equals to the first digit. Pauses between presses should not
exceed 1 second. More than 1 second pause will be interpreted as the start of
the next digit input. The immobilizer code can consist max of 4 digits from 1 to 9.
• Turn on the ignition to disable engine blocking or service mode, turning
USER MANUAL
7
Advertisement
Table of Contents
