Table of Contents
Advertisement
CONFIGURATION AND COMMISSIONING THROUGH PCS/XIP
XVP properties
XVP properties
XVP properties
Name
Name
Name
Address
Address
Address
ID
ID
ID
Addressing mode
Addressing mode
Addressing mode
IP address
IP address
IP address
Conversation time (s)
Conversati o n ti m e (s)
Conversati o n ti m e (s)
The "Ring time" is the maximum time for which the entry panel will ring while
The "Ring time" is the maximum time for which the entry panel will ring while
The "Ring time" is the maximum time for which the entry panel will ring while
waiting for an answer.Where the call is diverted, this timeout restarts with each
waiting for an answer. Where the call is diverted, this timeout restarts with each
waiting for an answer. Where the call is diverted, this timeout restarts with each
diversion. It must be longer than the "Ring time with diversion" configured on
diversion. It must be longer than the "Ring time with diversion" configured on
diversion. It must be longer than the "Ring time with diversion" configured on
the server.
the server.
the server.
Ri n g ti m e (s)
Ring time (s)
Ri n g ti m e (s)
Always send AUX
Always send AUX
Always send AUX
SIP username
SIP username
SIP username
Door openi n g ti m e (s)
Door openi n g ti m e (s)
Door opening time (s)
Dusk notified by
Dusk notified by
Dusk notified by
Door open al a rm ti m e (s)
Door open alarm time (s)
Door open al a rm ti m e (s)
Open door contact
Open door contact
Open door contact
Lift management aux.
Lift management aux.
Lift management aux.
Door release input notification
Door release input notification
Door release input notification
Customise tones
Customise tones
Customise tones
Door status
Door status
Door status
Active plate
Acti v e pl a te
Acti v e pl a te
Page 48 - Manual FA01812-EN - 06/2022 - © CAME S.p.A. - The contents of this manual may be changed at any time and without notice. - Translation of the original instructions
Create the system structure according to need.
From the list
Repeat the process to add any accessory modules or actions to activate the relay.
Select the devices entered and complete the properties.
<None>
<None>
<None>
Not active
Not active
Not active
Normally open (NO)
Normally open (NO)
Normally open (NO)
No event
No event
No event
Disabled (default)
Disabled (default)
Disabled (default)
Door status (default)
Door status (default)
Door status (default)
Active plate (default)
Acti v e pl a te (defaul t )
Acti v e pl a te (defaul t )
The device is part of a system based on the XIP system.
The system structure must be built with the PCS/XIP software.
1
, enter the entry panel by dragging it into the left-hand column
The [ID] and [IP address] fi elds are mandatory to proceed with confi guration.
2
.
Advertisement
Table of Contents
