Changing The Fuses Of Individual Power Consumers - Husqvarna TE 250i EU 2020 Owner's Manual

15 ELECTRICAL SYSTEM
15.5
114

Changing the fuses of individual power consumers

Info
The fuse box containing the fuses of individual power consumers is located under the seat.
H03747-10
Preparatory work
(All EU models)
–
Press and hold the switch-off button
idling until the engine stops.
(All US models)
–
Press and hold the switch-off button
idling until the engine stops.
–
Remove the air filter box cover. (
–
Remove the seat. ( p. 69)
Main work
–
1
Open fuse box cover
–
Remove the faulty fuse.
Guideline
(All EU models)
Fuse 1 - 10 A - EFI control unit, lambda sensor, oil
pump, combination instrument, electronic fuel injection,
diagnostics connector, ignition coil, oil level sensor
Fuse 2 - 10 A - horn, brake light, radiator fan (optional),
turn signal
Fuse 3 ‑ 10 A ‑ high beam, low beam, position light, tail
light, license plate lamp
Fuse 4 - 5 A - fuel pump
(All US models)
Fuse 1 - 10 A - EFI control unit, oil pump, combination
instrument, electronic fuel injection, diagnostics con-
nector, ignition coil, oil level sensor
Fuse 2 - 10 A - radiator fan (optional)
Fuse 3 - 10 A - low beam, position light, tail light
Fuse 4 - 5 A - fuel pump
Fuses res - 10 A - spare fuse
Info
A faulty fuse has a burned-out fuse wire
Warning
Fire hazard Incorrect fuses overload the electrical
system.
–
Only use fuses with the required ampere value.
–
Do not bypass or repair fuses.
–
Insert the spare fuse with the correct rating.
Fuse (75011088010) (
Fuse (75011088005) (
while the engine is
while the engine is
p. 70)
.
A
.
p. 151)
p. 151)