Husqvarna TE 250i EU 2020 Owner's Manual page 100

13 BRAKE SYSTEM
98
–
Stand the vehicle upright.
–
Remove the cable tie on the frame protector.
–
Remove screw cap
H03726-10
–
Manually press the brake caliper toward the brake disc to
push back the brake piston. Ensure that brake fluid does
not flow out of the brake fluid reservoir, if necessary extract
excess.
Info
Make sure that you do not press the brake caliper
against the spokes when pushing back the brake pis-
ton.
H03727-10
–
Remove cotter pin
–
Push spring plate
–
Remove the brake linings.
–
Clean the brake caliper and brake caliper bracket.
–
Check that spring plate
6
plate in the brake caliper bracket are seated correctly.
H03728-10
–
Insert the new brake linings.
–
5
Mount pin
Spring plate
Info
Always change the brake linings in pairs.
Make sure that decoupling plate
the piston side brake lining.
H03729-10
–
Mount cotter pins
–
Operate the foot brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
1 2
with membrane
3
.
4
downwards and remove pin
4
in the brake caliper and sliding
.
4
engages in the groove on the pin.
7
3
.
and the shim.
5
.
is mounted on