Table of Contents
Advertisement
Thermo Scientific
Unpacking
Section 3
Tools required for unpacking and assembly: 7/16" open end wrench,
common screwdriver, diagonal cutting pliers.
1. Remove parts box and still from shipping carton and place on
workbench.
2. Remove the two (2) shipping screws located on upper back of unit and
discard. Turn two (2) cover fasteners located on the lower front of unit
1/4 turn counterclockwise, and lift cover out and up to remove. Set
cover aside.
3. Check glassware inside the main cabinet for damage. Check parts in
the accessory box for damage. Identify any broken or damaged parts
and report them to your dealer immediately.
4. Using diagonal cutting pliers, cut and remove the five (5) plastic
shipping ties. The shipping tie locations are: two (2) on the condenser
"F", two (2) on the boiler "A", and one (1) on the trap "E".
Refer to Figure 3-1 for the following steps:
5. Remove product delivery tube from condenser "F" by removing clamp
"W" and packing material behind tube. Set tube and clamp aside.
Figure 3-1. Remove Packing Materials
11A Water Still
3-1
Advertisement
Table of Contents
