Setting Parameters For The Backfeed Protection Card - Huawei UPS5000-E User Manual

UPS5000-E-(400 kVA-600 kVA)
User Manual (60 kVA Power Modules)
Table 4-2 DIP switch address mapping (battery temperature sensor)
No
.
6
5
4
3
2
1
Step 2 Set UI parameters.
The address set on the software must be the same as the address set on the DIP
switch. Otherwise, the communication fails.
●
●
----End

4.1.3.4 Setting Parameters for the Backfeed Protection Card

Prerequisites
A backfeed protection card is installed.
Procedure
Step 1 On the LCD, choose System Info > Settings > Dry Contact Set and set MUE06A
connection to Enable.
Issue 09 (2023-07-10)
RS485 Address
16 17 18 19
0 0 0 0
1 1 1 1
0 0 0 0
0 0 0 0
0 0 1 1
0 1 0 1
NO TICE
The DIP switch address of an ambient T/H sensor ranges from 32 to 44.
LCD: Choose System Info > Settings > Comm. Settings > Amb. T/H Sensor,
and set Start address and Quantity.
WebUI: Choose System Settings > Comm. Settings > Amb. T/H Sensor, and
set Start address and Quantity.
When an ambient T/H sensor is used as a battery temperature sensor, the DIP
switch address ranges from 16 to 28.
LCD: Choose System Info > Settings > Comm. Settings > Batt Temp Sensor,
and set Start address and Quantity.
WebUI: Choose System Settings > Comm. Settings > Batt Temp Sensor, and
set Start address and Quantity.
Copyright © Huawei Digital Power Technologies Co., Ltd.
20 21 22 23
0 0 0 0
1 1 1 1
0 0 0 0
1 1 1 1
0 0 1 1
0 1 0 1
4 Single UPS Commissioning
24 25 26 27
0 0 0 0
1 1 1 1
1 1 1 1
0 0 0 0
0 0 1 1
0 1 0 1
28
0
1
1
1
0
0
123