Required Adjustment Tools - Epson Stylus Photo R2000s Series Service Manual

EPSON Stylus Photo R1900/R2880/R2000/R2000s/SC-P400 Series

5.1.3 Required Adjustment Tools

The following table lists the adjustment tools required for adjustment of this product.
Table 5-5. List of Tools
No. Name Part Code
Adjustment
1
Program
–
G-26
2 1080614
G-45
3 1033657
G-71
4 1304682
PG Adjustment
5 1276333
Gauge
PF Tension
6 1294120
Measuring Tool
PF Roller Shaft
7 1304993
Position
Adjustment Jig
Adjustment
Category Overview
This adjustment program is
Software
designed to display the required
adjustment items in the
appropriate order when a
replacement part is selected, and
provides workers with the
accurate adjustment order.
For the Parallelism Adjust
Grease
Bushing, Lower Paper Guide,
Driven Release Shaft, etc.
For the PF Roller, Front Paper
Grease
Guide, Rear Paper Guide and
etc.
For the Carriage Unit and
Grease
Carriage Shaft.
A gauge exclusively used to
Gauge
make PG Adjustment. Check
the correction value by
energizing it in the same way as
for Stylus Photo R1800.
Used to check whether or not
Measuring
the tension of the PF Drive Belt
tool
is within the specified value. If
load is greater than the specified
value, the PF Motor may
generate heat, burning off the
coil. Reversely, if load is less
than the specified value, the
paper feed position may shift.
Used to check whether or not
Adjusting
the deflection amount of the PF
jig
Roller Shaft is within the
specified value. Adjustment
values are confirmed in a pair
with the level block.
Adjustment Items and Overview
Table 5-5. List of Tools
No. Name Part Code
Level Block
8 1304994
Spanner (M3)
9 Commercially
available
Tester
10 Commercially
available
Note : For tools required for the Colorimetric Calibration, see P155.
Bring back the following brought and used items, then dispose of
C A U T I O N
them based on the local regulation in your country, please.

Ink cartridges

Cleaning cartridges

Draining cartridges
Especially in case of ink cartridges in Europe, please refer to the
following web site to confirm the regulation in detail.
ECO Info: http://www.epson.eu/weee (available from July 2015)
Revision I
Category Overview
Used to check whether or not
Adjusting
deflection amount of the PF
jig
Roller Shaft is within the
specified value. Adjustment
values are confirmed in a pair
with the PF Roller Shaft
Position Adjustment Jig.
Used to loosen the screw that
Tool
secures the Center Support
Bushing when performing PF
Roller Shaft Center Support
Position Adjustment.
Used to confirm the output
Measuring
voltage from the High Voltage
tool
Module falls within the
specified range.
145