Procedure Of Disassembly - Epson Stylus Photo R2000s Series Service Manual

Stylus Photo R1900/R2880/R2000/R2000s/SC-P400 Series

8.3.2 Procedure of Disassembly

The flowchart below lists the step-by-step disassembly procedures.
Start
Front Decoration
Rear Housing
Plate Left/Right
(p.79)
(p.79)
Front Decoration
Plate Left/Right
(p.79)
Decoration Plate
Left/Right (p.82)
Panel FFC Cover
(p.187)
Panel Unit
(p.188)
Upper Housing /
Printer Cover (p.83)
Upper Housing
PF Encoder
Support Assy (p.85)
(p.134)
Lower Housing /
Printer Mechanism
(p.98)
ASF Assy PF Motor
(p.108) (p.132)
Release Holder
PE Sensor Holder
Assy (p.127)
(p.137)
FLAG Release
Assy (p.128)
PE Sensor Holder
(p.137)
Upper Paper Guide
Assys (p.129)
Stylus Photo R2000/R2000s
Paper Support Assy
Panel FFC Cover
(p.187) (p.78)
Cover Open Sensor
Panel Unit
(p.138)
(p.188)
High Voltage LED Board
Module (p.89) (p.88)
Waste Ink Pad / Waste
Front Paper Guide
Ink Tube Left/Right
Pad (p.111)
(p.112)
ASF Motor
(p.133)
C H E C K
Stacker Assy
P O I N T
(p.78)
APG Assy CR Scale
(p.91)
(p.92)
Paper EJ Frame
Assy / Front Cover
/ CDR Tray Base
PictBridge Holder
Foot (p.113)
Assy (p.113)
Front Paper Guide / CDR Release
Lever Sub Assy
Paper EJ Roller / Front
Paper Guide Pad Tray
(p.121)
Ink System Unit
PF Encoder
(p.134)
Upper Paper Guide
Assys (p.129)
PF Roller Shaft
(p.124)
Disassembly

The boxes shown in a dotted-line are not the shortest
procedures, but are necessary to proceed to the next step.

Since a prototype was used to illustrate these disassembly
and assembly procedures, the appearance of some parts
may differ from those on an actual product.

This section describes the parts of red frame only. For
other parts, please refer to the procedure of Stylus Photo
R1900 / R2880/R2000/R2000s.
Printhead / CSIC
CR Motor Wireless LAN Board
Assy (p.94)
(p.131) Assy (p.190)
Board Assy (Main
CR Scale
Board / Power Supply
Board) (p.191)
(p.114)
LED Board
(p.88)
APG Assy
CDR Sensor
(p.91)
(p.136)
(p.116)
Carriage Shaft /
Carriage Unit
(p.118)
Ink Mark Sensor /
PW sensor (p.135)
Revision I
(p.92)
CR Encoder
(p.134)
186