Table of Contents
Advertisement
Chapter 2:
Installing the DXF System
Unpacking/Repacking
You may wish to retain all the shipping hardware, the plywood, and boxes from the instrument in the event
you wish to repack and ship your instrument.
Installing the System
Before shipment, the DXF is inspected both electrically and mechanically so that it is ready for operation
upon proper installation. Only limited instructions are given in this manual; consult the Help documenta-
tion for additional information. Installation involves the following procedures:
•
Inspecting the system for shipping damage and missing parts
•
Choosing a location for instrument installation
•
Connecting the Environmental Module to Pulse Source Module
•
Setting up system communication with the controller
•
Connecting the utilities
It is strongly recommended that you have your DXF system installed by a TA Instruments Service Repre-
sentative; call for an installation appointment when you receive your instrument.
CAUTION: To avoid mistakes, read this entire chapter before you begin installation.
MISE EN GARDE: Pour éviter de commettre des erreurs, lisez tout le chapitre avant de commencer
l'installation.
Inspecting the System
When you receive your DXF system, look over the instrument and shipping container carefully for signs of
shipping damage, and check the parts received against the enclosed shipping list.
•
If the instrument is damaged, notify the carrier and TA Instruments immediately.
•
If the instrument is intact but parts are missing, contact TA Instruments.
DXF-200 Getting Started Guide
Page 17
Advertisement
Table of Contents
