Setting Up System Communication With The Controller - TA Instruments DISCOVERY XENON FLASH Getting Started Manual

Setting Up System Communication with the Controller

1 Place the computer and monitor to the side of the unit and connect the keyboard and mouse.
2 Connect the USB cable from the back of the DXF to the controller.
3 Connect the USB1 cable from the back of the DXF to the controller.
4 Connect the monitor cable to the monitor port on the computer.
5 Connect the temperature controller communication cable.
6 Connect the power cords to the computer and monitor and plug them into the same wall outlets on the
same circuit that the DXF is plugged into.
7 Turn on the computer and monitor.
DXF-200 Getting Started Guide Page 25