Table of Contents
Advertisement
Applying Graphite Spray
The following is the procedure for coating samples with graphite spray:
NOTE: Only one side (the bottom) of the sample should be coated with graphite spray.
1
Place the samples onto a plain sheet of paper. Locate them in one line close to each other.
2
Using a heat gun, gently warm the samples.
3
Hold the aerosol can of graphite spray approximately 8–10 inches from the samples. Using a single,
fluent motion spray the exposed surfaces from left to right.
4
Allow one minute for the coating to dry on the samples.
5
Following the same path as in step 3, apply a second coating across first pass.
6
Allow a minimum of 3 minutes for the samples to dry before coating the other side. Repeat steps 2
through 6.
7
After drying, store the samples on a soft surface (ex: tissue paper).
DXF-200 Getting Started Guide
Page 32
Advertisement
Table of Contents
