FLIR DNR700 Series Instruction Manual page 82

14 Using the Main Menu
can reduce the amount of wear on the hard drives and may extend the life of the hard
drives.
NOTE
• Two hard drives must be installed in the system to use hard drive groups, and both hard drives must
be formatted as Read-write hard drives. For details on installing hard drives, see 22 DNR700 Series
Hard Drive Installation, page 173.
To configure hard drive groups:
1. From the Main Menu, click
Setting.
2. Under HDD Group, assign a group to each hard drive. To set up two hard drive
groups, assign one hard drive to group 1 and the other to group 2.
3. Click OK. The system will restart to apply changes.
4. When the system restarts, you must decide which channels will record to each hard
drive group.
5. From the Main Menu, click
Stream. For each channel, select the hard drive group you would like to record the
main stream (high quality) video and then click Apply.
#LX400082; r. 1.0/38226/38226; en-US
and then click Storage>HDD Advance>HDD
and then click Storage>HDD Advance>Main
72