FLIR DNR700 Series Instruction Manual page 178

21 Connecting a PTZ Camera (DNR700 Series)
To connect a PTZ camera to the system via RS485:
1. Connect the camera Ethernet cable to one of the PoE Ports on the system.
OR
Connect the camera to the local network (LAN) and then add it to the NVR. See 5.11
Connecting Cameras to the Local Area Network (LAN), page 12 for details.
2. Right-click and click Main Menu. Enter the system user name (default: admin) and
password (default: 000000) if prompted.
3. Click >Setting>Pan/Tilt/Zoom.
4. Under Channel, select the channel your PTZ camera is connected to.
5. Under PTZ Type, select Local. This allows the system to control the PTZ functions
over RS485. Configure the following RS485 connection parameters for your camera:
• Protocol.
• Address.
• Baud Rate.
• Data Bit.
• Stop Bit.
• Parity.
NOTE
Check the instruction manual for your PTZ camera to determine the correct settings.
#LX400082; r. 1.0/38226/38226; en-US
168