Basic Setup (Dnr700 Series); Step 1: Connect The Ip Cameras; Step 2: Connect The Mouse; Step 3: Connect The Ethernet Cable - FLIR DNR700 Series Instruction Manual

5

Basic Setup (DNR700 Series)

5.1 Step 1: Connect the IP Cameras

Option 1: Direct Connection to NVR
• Connect cameras to the PoE Ports on the rear panel of the NVR using Cat5e or higher
grade Ethernet cable. The cameras will appear on the NVR without any additional con-
figuration when the system starts up.
Connect IP cameras directly to PoE ports.
Option 2: Connect Cameras to Local Network
You can also connect your IP cameras to your local network for flexible installations. For
details, see 5.11 Connecting Cameras to the Local Area Network (LAN), page 12.

5.2 Step 2: Connect the Mouse

• Connect a USB mouse (included) to one of the USB ports.

5.3 Step 3: Connect the Ethernet Cable

• Connect an Ethernet cable (included) to the LAN port on the rear panel of the system.
Connect the other end of the Ethernet cable to a router on your network.

5.4 Step 4: Connect the Monitor

• Connect the included HDMI cable from the HDMI port to the TV or monitor
(recommended).
OR
#LX400082; r. 1.0/38226/38226; en-US
8