Creating Custom Channel Names - FLIR DNR700 Series Instruction Manual

14 Using the Main Menu
3. Configure the following settings for snapshots saved automatically from motion detec-
tion or the snapshot schedule:
• Channel: Select the channel you would like to configure.
• Mode: Select Timing for the system to take snapshots according to the snapshot
schedule (see 14.3.17 Configuring the Snapshot Schedule, page 67) Select Trig-
ger for the system to take snapshots only when triggered by motion detection
(snapshot must be enabled in the Motion Detect menu; see 14.3.8 Configuring Mo-
tion Detection, page 59).
• Image Size: The image size is the same as the Main Stream resolution of the
camera.
• Image Quality: Select the snapshot image quality between 1 (lowest) and 6
(highest).
• Snapshot Frequency: Select the number of snapshots (up to 6) the system will
take each time.
4. Click OK to save changes.

14.1.9 Creating Custom Channel Names

You can assign custom names to your cameras. For example, you can name your cameras
based on their location (e.g. hallway or front door).
To create custom channel names:
1. From the Main Menu, click
2. Enter a custom name for each channel.
3. Click OK to save changes.
#LX400082; r. 1.0/38226/38226; en-US
and select Channel Name.
49