Tours; Pattern - FLIR DNR700 Series Instruction Manual

21 Connecting a PTZ Camera (DNR700 Series)

21.2.2 Tours

Tours will cycle through a set of presets.
To create a tour:
1. Click to open the aux menu.
2. Click the Tour tab.
3. Under Patrol No., select the tour you would like to configure.
4. Under Preset, select a preset you would like to add to the tour.
5. Click Add Preset.
6. Repeat steps 4 and 5 to add additional presets to the tour.
NOTE
Click Del Tour to clear all presets from a tour.
To run a tour:
• Under No., select the number of the tour you would like to go to and click

21.2.3 Pattern

Patterns automatically cycle the camera between two positions.
To create a pattern:
1. Click to open the aux menu.
2. Click the Pattern tab.
3. Under Pattern, enter the pattern you would like to configure.
4. Move the camera into the desired start position and click Begin.
5. Move the camera into the desired end position and click End.
To run a pattern:
#LX400082; r. 1.0/38226/38226; en-US
.
171