Table of Contents
Advertisement
Optional front bezel dust filter
Some models are equipped with an optional front bezel dust filter. You must periodically clean the dust filter
so that the dust collected on the filter does not impede air flow through the computer.
NOTE:
The optional front bezel dust filter is available from HP.
To remove, clean, and replace the dust filter:
1.
Prepare the computer for disassembly
2.
To remove the dust filter, use your fingers to separate the filter from the front bezel at the tab locations
shown below.
3.
Use a soft brush or cloth to clean dust from the filter. If heavily soiled, rinse the filter clean with water.
To replace the filter, reverse the removal procedures.
24
Chapter 4 Removal and replacement procedures
(Preparation for disassembly on page
17)
Advertisement
Table of Contents
