Table of Contents
Advertisement
Extender Position
The extender position allows you to load the bed of the
truck beyond the tailgate. The bed extender will add an
additional 15 inches (38 cm) in the back of the truck when
additional cargo room is needed. The extender position
utilizes a locating pin and rotating handle located on both
sides of the truck bed near the tailgate.
Extender Position
To install the bed extender into the extender position,
perform the following:
1.
Lower the tailgate.
2.
Make sure the center handle is unlocked and rotate
the center handle vertically in order to release the
extender side gates.
3.
Fit the end of the side gate ends onto the pin and
handle.
Extender Installation
4.
Rotate the handles to the horizontal position to
secure into place.
Locking Tab
GETTING TO KNOW YOUR VEHICLE
WARNING!
To reduce the risk of potential injury or property
damage:
Cargo must be secured.
Do not exceed cargo load rating of your vehicle.
Secure all loads to truck utilizing cargo tie downs.
Extender should not be used as cargo tie down.
When vehicle is in motion do not exceed 150 lb
(68 kg) load on the tailgate.
The bed extender is not intended for off road use.
When not in use, the extender/divider should be in
stowed or divider position with the tailgate closed.
When in use all handles are to be in the locked
position.
Storage Position
The storage position for the bed divider is at the front of
the truck bed which maximizes the bed cargo area when
not in use.
85
2
Advertisement
Table of Contents
