Table of Contents
Advertisement
CAUTION!
Do not contaminate the bulb glass by touching it with
your fingers or by allowing it to contact other oily
surfaces. Shortened bulb life will result.
Always use the correct bulb size and type for replace-
ment. An incorrect bulb size or type may overheat
and cause damage to the lamp, the bulb socket, or
the lamp wiring.
6.
Rotate the bulb counterclockwise a quarter turn to
unlock the bulb from the lamp.
7.
Pull the bulb straight out from the housing.
8.
Reverse the procedure for installation of new bulb
and covers.
High Beam
High Beam Headlight Cover
See the following steps to replace:
1.
Open the hood.
2.
Disconnect and isolate the negative battery cable.
3.
Locate the high beam access cover, which can be
found on the back side of the headlamps.
NOTE:
It may be necessary to remove/reposition Air Cleaner
Assembly to access passenger side headlamp/side
marker light bulbs.
4.
Reach behind the headlamp and disengage the
access cover by rotating counterclockwise.
5.
Disconnect the internal lamp wiring harness
connector from the high beam bulb.
CAUTION!
Do not contaminate the bulb glass by touching it with
your fingers or by allowing it to contact other oily
surfaces. Shortened bulb life will result.
Always use the correct bulb size and type for
replacement. An incorrect bulb size or type may
overheat and cause damage to the lamp, the bulb
socket, or the lamp wiring.
6.
Rotate the bulb counterclockwise a quarter turn to
unlock the bulb from the lamp.
7.
Pull the bulb straight out from the housing.
8.
Reverse the procedure for installation of new bulb
and cover.
SERVICING AND MAINTENANCE
Front Park And Turn
See the following steps to replace:
1.
Open the hood.
2.
Disconnect and isolate the negative battery cable.
3.
Locate the park and turn socket, which can be found
on the back side of the headlamps.
Park And Turn Socket
4.
Reach behind the headlamp and unlock the park and
turn socket from the lamp by rotating counter-
clockwise a quarter turn.
5.
Pull the bulb straight out from the housing.
6.
Separate the bulb from the socket without twisting.
7.
Reverse the procedure for installation of new bulb
and covers.
367
8
Advertisement
Table of Contents
