Table of Contents
Advertisement
2.
Pull the outboard side of the lamp rearward far
enough to unsnap the two receptacles on the
outboard side of the lamp housing from the two
plastic snap post retainers in the outer box side
panel.
Tail Lamp Removal
3.
Disconnect the wiring harness connectors from the
bulb socket.
Wiring Harness Connector
4.
Rotate the bulb socket counterclockwise a quarter
turn to unlock it from the housing.
5.
Pull the bulb straight out of the socket.
CAUTION!
Do not contaminate the bulb glass by touching it with
your fingers or by allowing it to contact other oily
surfaces. Shortened bulb life will result.
6.
Reverse the procedure to install the bulb and
housing.
CENTER HIGH MOUNTED STOP LAMP (CHMSL)
WITH CARGO LAMP
See the following steps to replace:
1.
Remove the four screws holding the housing/lens to
the body as shown.
CHMSL Mounting Screw Locations
SERVICING AND MAINTENANCE
2.
Separate the connector holding the housing and
wiring harness to the body.
CHMSL Bulb Location
3.
Turn the desired bulb socket a quarter turn counter-
clockwise and remove the socket and bulb from
housing.
4.
Pull the desired bulb straight from the socket.
CAUTION!
Do not contaminate the bulb glass by touching it with
your fingers or by allowing it to contract other oily
surfaces. Shortened bulb life will result.
Outside Bulbs: Cargo Lamps
Inside Bulb: Center High Mounted Stop Lamp
5.
Reverse the procedure for installation of bulbs and
housing.
369
8
Advertisement
Table of Contents
