Table of Contents
Advertisement
368
SERVICING AND MAINTENANCE
Side Marker Lamp
See the following steps to replace:
1.
Open the hood.
2.
Disconnect and isolate the negative battery cable.
3.
Locate the side marker lamp, which can be found on
the back side of the headlamps.
Side Marker Lamp
4.
Disengage the side marker socket by rotating
counterclockwise a quarter turn.
5.
Pull the socket and bulb straight out from the
housing.
6.
Separate the bulb from the socket without twisting.
7.
Reverse the procedure for installation of new bulb
and covers.
FOG LAMPS — IF EQUIPPED
Please see an authorized dealer for service on LED and
Halogen front fog lamps.
Halogen
See the following steps to replace:
1.
Reach under and behind the front fascia/bumper to
access the back of the front fog lamp housing.
2.
Disconnect the fog lamp wiring harness connector
from the fog lamp bulb.
Fog Lamp Bulb
3.
Rotate the bulb counterclockwise a quarter turn to
unlock the bulb from the housing.
4.
Pull the bulb straight out from the housing.
5.
Reverse the procedure to install the bulb and cover.
CAUTION!
Do not contaminate the bulb glass by touching it with
your fingers or by allowing it to contact other oily
surfaces. Shortened bulb life will result.
REAR TAIL/STOP, TURN SIGNAL AND BACKUP
LAMPS
1.
Remove the two screws and pushpin retainers that
pass through the bed sheet metal.
Tail Lamp Locations
1 — Tail Lamp
2 — Fasteners
3 — Pushpin Retainers
Advertisement
Table of Contents
