The Kf4-We And Keyfob-We (Wireless Keyfobs); Locking The Keyfob; Buttons; Quick Setting - Pyronix RINS1902-2 User Manual

4 . T h e K F 4 - W E a n d K E Y F O B - W E ( W i r e l e s s K e y f o b s )
The wireless keyfob has 4 buttons that may be programmed for specific purposes (please see 'EDIT
USERS?' on page 17 for more information).

4.1 Locking the Keyfob

All 4 buttons on the keyfob may be 'locked' so that any accidental presses will not affect your
wireless alarm system (for example, this protects the buttons from being pressed accidently if a
keyfob is in someone's pocket).

4.2 Buttons

The buttons can be customised (see Change Codes, page 17) to operate as desired. The table
below gives the defaults of how each button is programmed. These can be changed in the 'Edit
Users' function – see page: 17.
LOCK BUTTON = Set Area A
When pressed, the Area A will start to set.
UNLOCK BUTTON = Unset Area.
When pressed, the wireless alarm system will unset any area that is
already set.
I BUTTON = Set Area B
When pressed, the Area B will start to set.
II BUTTON = Show Status
When pressed, if the GREEN LED is shown then the wireless alarm system
will be unset. If the RED LED is shown then the wireless alarm system will
be set.

4.3 Quick Setting

If one of the buttons is programmed as 'Set Area', the wireless alarm system can be set by
pressing the programmed button on the keyfob. The keypad will then start to count down the
exit time, or wait for a 'final door' to be opened and closed or wait for a Push to Set (PTS)
button to be pressed (depending what the exit mode is programmed as by the engineer).
Once the alarm panel is in this 'setting' stage, it is possible to 'quick set' the system by pressing
the same button again; this will reduce the time to set to 'immediate setting'. The alarm panel
will revert to the normal display with the time showing, but a beep will be heard once the
system has been set.
Wireless Alarm System: User Manual
5