Communication Between Laboratory Instrument And Pc; Motor Protection / Safety Device - IKA KS 130 control Operating Instructions Manual

Communication between laboratory instrument and PC

PC 1.5 Cable
This cable is required to connect the 15-pin connector to a PC (25-pin connector).
PC 2.1 Cable
This cable is required to connect the 9-pin connector to a PC.
PC 1.2 Adaptor
This adaptor is required to connect the 9-pin connector to an 8-way serial interface
(25-pin plug).
Device software update
Keep your device up-to-date with the IKA Firmware update tool.
The firmware update can be done with a computer connected through USB-Interface.
For this, you need register on our website MyIKA first.
After registering your device IKA will inform you about available updates for your
devices.
Please download the software "FWUToolSetup.zip" from our IKA service website
www.ika.com.
30

Motor protection / safety device

If the motor is locked or if a load is placed on it resulting in a higher temperature than
permitted, the device is turned off automatically by the safety circuit. To eliminate
the error, the weight of the material must be reduced. Allow the device to cool off.
The device must be turned off and back on again.
The motor is turned off immediately in the event of a malfunction by a safety circuit.
A malfunction occurs if the safe and secure functionality of the device cannot be
guaranteed. A malfunction is displayed by the error message being shown on the
display of the speed indicator (see the section "Error Codes").