Unpacking; Useful Information; Commissioning - IKA KS 130 control Operating Instructions Manual

Unpacking

Unpacking:
- Unpack the device carefully.
- Any damage should be notified immediately to the shipping agent (post
office, railway network or logistics company).
Delivery scope:
The scope of delivery includes: One shaker, 4 clamping screws, one single open-
ended spanner, a power cable and an operating instructions.

Useful information

With the purchase of this device, you have acquired a high-quality product.
The design of the device and its special shape ensure ease of handing and
problem-free work. The materials used and an exact designation of them will
significantly facilitate and simplify recycling and reuse of parts.
The speed-controlled external rotor asynchronous motor enables precise speed
adjustment in the range from 80 to 800 rpm (KS 130 control / KS 130
control NOL) / 10 to 500 rpm (KS 260 control / KS 260 control NOL)
and 10 to 300 rpm (KS 260 control / HS 260 control NOL). The electronic
motor control keeps the set speed constant even if the support weight on
the table increases. The heat dissipated by the motor can heat up the holding
surface for the shaking containers.
The control device is equipped with a locking mechanism. This makes it
possible to fasten the shaking table in a defined position. For example the
device can be integrated into a system or screwed with a table. In addition,
the rubber feet must be unscrewed from the base plate so that the exposed
threaded hole (M6) can be used to secure the device. Make certain that the
maximum depth of 5 mm for inserting the screws is not exceeded.
The control device can be delivered with a reverse operating mode (clockwise
/ counterclockwise motion) for the vibration table on request. However, the
reverse operation mode can only be used by means of the serial interface in
combination with a PC (for example with Labworldsoft
20
It is easy to exchange the various attachments.
The control device and control NOL device are equipped with a serial
interface that makes it possible to control the device through the PC (for
example with Labworldsoft

Commissioning

Check whether the voltage specified on the type plate matches the mains
voltage available.
The power socket used must be earthed (protective earth conductor contact).
If these conditions are met, the device is ready to operate after plugging in the
mains plug.
If these procedures are not followed, safe operation cannot be guaranteed and/
or the equipment may be damaged.
Observe the ambient conditions (temperature, humidity, etc.) listed under
Technical Data.
If the mounting surface is not even, you can improve the safety level of the
device in reference to how it stands with the adjustable feet.
® ).
® ).
To do this, turn the appropriate device
foot downward with the wrench
(included with delivery) until the device
is standing securely on the surface.
A
To prevent the foot of the device from
coming loose by itself, hold down the
foot with one hand and tighten the
opposite hexagonal nut with the other
hand until it is finger tight.