Working With The Device - IKA KS 130 control Operating Instructions Manual


Speed limit stored
Then the speed setting (e.g. 130 [rpm]) and the timer setting (e.g. 03:58 [h:min])
appear on the screen.

Set values
The device is ready for operation.

Working with the device

Setting the speed
Switch on the device with the power switch and wait until the device is ready
for operation. The set speed (e.g. 130 [rpm]) is displayed on the left, the LED of
the set indicator lights up.
The set speed can be changed by turning the left rotary knob. Changing the
speed is also possible while the device is shaking.
Setting the timer value
Switch on the device with the power switch and wait until the device is ready
for operation. The timer value (e.g. 3:58 [h:min]) is displayed on the right, the
LED of the set indicator lights up.
The timer value can be changed by turning the right rotary knob. Changing
the timer value is also possible while the device is shaking. Once the timer has
started, however, the value can no longer be changed.
22
Shaking function without timer
If the shaking function is started by pressing the left rotary knob, the left display
shows the actual speed and the shaking function indicator LED lights up. The right
display shows the time value.
The device regulates the speed to reach the set speed. The display shows the
actual speed for 4 seconds and only the shaking function indicator LED lights up.
Then, the display shows the set speed, the LED of the set indicator and the LED
of shaking function indicator light up. Then the actual speed is displayed again
for 4 seconds, etc.
Pressing the left rotary knob again to stop the shaking function. The display
shows the set values and the LED of the set indicator lights up.
Shaking function with timer
During the shaking process, the timer function can be switched on by pressing
the right rotary knob. From now on, the timer runs.
The shaking process and the timer function can also be started simultaneously
by pressing the right rotary knob.
The two LED dots between h and min flash every second while the timer is running.
The shaking process and the timer can be stopped by pressing the right or left
rotary knob. It is not possible to stop one of the functions separately.
After the timer has run out and the shaking process has been stopped automatically,
or manually by pressing one of the two rotary knobs, the display shows the set
values.