Unpacking The Library - Quantum PX506 Unpacking And Installation Instructions

Quantum PX506 and PX510 Unpacking and Installation Instructions
Document 81-81338-01 D01
June 2005

Unpacking the Library

8
• Do not place static-sensitive parts on a metal surface. Place them inside
their protective shipping bag or on an antistatic mat.
• Avoid touching connectors and other components.
Dry climates and cold-weather heating environments have lower
Note:
relative humidity and are more likely to produce static electricity.
Inspect the outer library packaging for damage. If there is any
Note:
damage evident on the library packaging, to not continue with the
installation and contact Quantum customer support.
This section explains how to unpack both the PX506 and PX510 library
components and move them to their final installation location. By following
these instructions, you help ensure that the system will continue to be
safeguarded after it arrives at the installation site.
Unpack the library as close to the installation location as possible.
Note:
Unpack and remove the following components from the packing materials
(see figure 4 for PX506 and
1 Remove the accessories kit and set it aside.
At least two people are required to move the library
Warning:
chassis.
Lift the library chassis at the sides. Avoid putting the
Caution:
weight of the library chassis on the front bezel.
2 With the help of a second person, lift the library chassis up and out of the
shipping carton.
3 Place the library on a table approximately waist high.
Unpacking the Library
figure 5 for PX510):
0