Table of Contents
Advertisement
Chapter 10 Utilities
3
An icon for the mapped share will appear in Computer or This PC. You can use this network drive just like any
other drive.
Changing the IP Address
1
Double-click the NAS Navigator2 icon (
2
Right-click your Buffalo NAS device's icon and select Properties > IP Address.
3
Clear the "Use DHCP" checkbox and enter the desired settings, then click OK. If the username and password
prompt appears, enter the admin username and password.
NAS Navigator2 for macOS
NAS Navigator2 is a utility program that makes it easy to display Settings, change the Buffalo NAS device's IP
address, or check its drive. To install NAS Navigator2, download the installer from http://d.buffalo.jp/LS220DB/.
Click the NAS Navigator2 icon (
Click a Buffalo NAS device's icon to display total capacity, used space, workgroup name, IP address, subnet mask,
default gateway, MAC address, and firmware version.
Double-click the icon to open a shared folder on the Buffalo NAS device.
Name
Open
Refresh
Settings
Configure
Label Color
) to start NAS Navigator2.
) in the Dock to start NAS Navigator2.
Description
Opens the Buffalo NAS device's shared folders.
Searches for the Buffalo NAS devices on the network again.
Opens Settings for the Buffalo NAS device.
Opens the properties page that lets you configure the
Buffalo NAS device's IP address or open Settings.
Selects the color of the name displayed below the icon.
114
Advertisement
Table of Contents
