Table of Contents
Advertisement
Quantum DX3000 and DX5000 User's Guide
4 Enter the alpha characters (0 to 6 characters) in the
field.
If you are entering alpha characters for the first part of a
Note:
barcode number and this is the first number in a range, no
more than five characters can be used. This allows the
system to assign the last character in the field.
5 Enter the numeric character in the
This number is used as the first number in the range of
Note:
tape cartridges. The number will increment with each
additional cartridge in the field.
6 When you have selected the tape(s) and both the alpha and numeric
characters, click
Apply
Barcode labels are assigned for the selected tape(s).
7 Return the DX3000/DX5000 system to the on-line state (see
"Changing Library State"
Configuring Library Properties
The library name identifies the DX3000/DX5000 system so it can be
distinguished from other devices on the network through the SNMP
interface.
To set the library name:
1 Set the DX3000/DX5000 system to the off-line state (see
Library State"
on page 84).
2 From the
Library
link.
The
page displays (see
Properties
Chapter 3 DX3000 and DX5000 Remote Management
Numeric Ending
.
on page 84).
link of the
Configuration
figure
Configuration
New Alpha Prefix
field.
"Changing
page, click the
Properties
27).
3
43
Advertisement
Table of Contents
