2.
Remove the front cover by loosening the
split pin. (Complete instructions for the
service position can be found on the
inside of the front cover).
3.
Loosen the two anti-scalp rollers, located
under the front cover.
4.
Fit the two anti-scalp rollers on each side
of the cutting unit's rear section.
!
WARNING!
Wear protective glasses when
dismantling the cutting unit. The
springs that tension the belt can fly
off and cause personal injury.
90
English-
REPAIR INSTRUCTIONS
Dismantling the front cover
Support wheels
Placement of the anti-scalp rollers