Table of Contents
Advertisement
5) Remove the Frame Cover Section. (See Fig. 10.)
1. Remove the "S-11" and "S-10" screws shown in Fig. 10. The S-12 screw is removed only when the Main
Board Assy is not removed. (Remove the connector connected to the Main Board Assy.)
6) Remove the Switch Board Assy. (See Fig. 11.)
1. Remove the "S-10" screw shown in Fig. 11.
2. Remove the "S-6" screw shown in Fig. 11 and then remove the Switch Board Assy.
Note:
Be careful not to mistake the hole through which the Switch Harness is passed. (See Fig. 12.)
SW Board Assy
Switch Harness
Cap L
Cap R
S-6
Fig. 11
DISASSEMBLY AND ASSEMBLY
S-11
S-11
S-12
Fig. 10
S-10
11
Cap R
Cap L
[Front Side]
[Other Side]
Switch Harness
Fig. 12
Advertisement
Table of Contents
