Table of Contents
Advertisement
3) Remove the Power Unit. (See Figs. 6, 7, and 8.)
1. Remove the PU Cover B shown in Fig. 6. (The PU
Cover B is attached using a double-coated tape.)
2. Disconnect the connectors (CN3 and CN9) con-
nected to the Power Unit shown in Fig. 7.
3. Remove the "S-9" screw shown in Fig. 8 and then
remove the Power Unit.
Notes:
• Connect connectors (CN3 and CN9) before install-
ing the PU Cover B.
• A toothed washer (S-13) is put in the screw on the
inlet side when the Power Unit is installed.
CN4
(4pin)
CN3
(9pin)
4) Remove the CCD Board Unit. (See Fig. 9.)
1. Remove the "S-4" screw shown in Fig. 9 and then
remove the CCD Board Unit.
Note:
The CCD Board Unit requires adjustment when it is
replaced and removed. (See 5. Adjustment.)
Fig. 7
DISASSEMBLY AND ASSEMBLY
PU Cover B
S-9
CCD Board Unit
CCD Harness Assy
10
Fig. 6
PU Plate B
PU Plate A
Power Unit
S-13
S-9
Fig. 8
S-4
S-4
Fig. 9
Advertisement
Table of Contents
