Controls And Connections; Main Unit Top Panel - Laversab 6300-M4 User Manual

Note: Pt = Pitot and Ps = Static
2.1

MAIN UNIT TOP PANEL

The model 6300-M4 top panel provides easy access to all the connections.
Please refer to Figure 2.1.
[1] AC INPUT connector :
This is a 3-pin male circular connector. A power cord is provided with the 6300-M4. The
circular connector end of the power cord needs to connected here. The power requirement of
the 6300-M4 is 90-260 VAC, 47-440 Hz with a maximum power consumption of 150 VA.
Caution: Connecting incorrect power to the 6300-M4 will cause considerable damage
[2] Fuse :
A 5x20 mm fuse is located inside the fuse holder. The fuse is a time-delay fuse with a rating of
2.0 amps, 250 Volts.
[3] AC On/Off switch :
This toggle switch connects (or disconnects) AC power between the AC INPUT connector and
the 6300-M4. Even when this switch is ON, the 6300-M4 becomes operational only after the
On/Off switch located on the right side of the Remote Unit is turned ON. (Push in to turn
ON)
[4] Remote Unit connection:
The 6300-M4 is provided with a 50 foot remote cable to connect to the Remote unit. The male
end of the remote cable is connected here on the top panel. The female end of the remote
cable is connected to the Remote unit. This cable should be connected prior to applying
power to the 6300-M4. This cable should not be disconnected while power is applied to the
6300-M4.
SECTION 2

CONTROLS AND CONNECTIONS

2