Table of Contents
Advertisement
3.5
FUNCTION SELECT SCREEN
There are 8 different functions that can be performed. These are:
1. View Limits
2. Set or Change Limits
3. Set or Change the knots rate
4. View or Execute profiles
5. Setup profiles
6. Height Correction
7. Set Ground
8. Go To Ground
Pressing the "Function Select" key on the keypad allows you to go into the function select
screen which is shown below.
Select function
1.
View limits
2.
Set limits
3.
Set knots rate ... now at 500.0 kts/min
If you want to select functions 4 through 8, press the Down Arrow key on the keypad to move
to the screen shown below.
Select function
4.
Execute profile
6.
Height Correction
8.
Go to "Ground"
Once in the correct screen, select a number to go to the desired function. An explanation of
each of the functions is given below.
3.5.1 FUNCTION 1 : VIEW LIMITS
The 6300-M4 checks both the Target values and the Actual values to determine if they are
within specific limits. These limits can be set by the user. To view these limits, you can press
the Function Select key and then choose Function 1 (View Limits) by pressing "1". The VIEW
LIMITS screen appears as shown below.
( DN ARROW for functions 4 to 8 )
( UP ARROW for functions 1 to 3 )
5.
Set profiles
7.
Set "Ground"
29
Advertisement
Table of Contents
