Table of Contents
Advertisement
LIMITS screen.
3.5.3 FUNCTION 3: SET KNOTS RATE
Pressing "3" on the Function Select screen brings you into the "Set Knots Rate" screen. This
screen is shown below.
CURRENT RATE = 250.0
NEW RATE =
min : 50 ,
The knots rate is the rate at which the Actual airspeed value is ramped towards the Target
airspeed value. A typical knots rate value of 500.0 is ideal for most operations. Enter the
desired value followed by the ENTER key. This will take you into the following screen which
shows that a new value of 300.0 was entered. Press GO to return to the Main screen.
Thank you.
NEW RATE = 300.0
3.5.4 FUNCTION 4: VIEW & EXECUTE PROFILES
To execute a profile, press Function Select and then press "4". This will bring you back into
the Main Screen as shown below. You will need to enter the profile number that you want to
execute. A full explanation of profiles is given in Section 4.
Units:
Actual:
Target:
ENTER PROFILE NUMBER :
Assuming you enter a profile number of "2.1", followed by the ENTER key, the first point of
profile # 2 will be displayed on the screen. Also, the name of the profile is shown here. This is
shown in the screen below. The name of profile 2 is CJ1-RVSM. In this profile note that both
Modes changed to "C", and all three target values changed.
programmed as the first point of profile # 2. You will also notice that the number "2.1" is
knots /min.
knots /min.
max : 500
Press "GO" to continue.
knots /min.
knots
M
101.2
20.0
32
Feet/min
Feet
3500
1005
3000
.
M
0
These parameters were
Advertisement
Table of Contents
