Executing A Profile - Laversab 6300-M4 User Manual

you want to transfer. Open this file. You will see the profile being downloaded as it
is echoed back from the 6300-M4.
4. After the profile has completed downloading, the last section should say "PASS". If
it does not then the profile did not download correctly. If no characters are echoed
when you open the .txt file to download then you probably have a communication
problem.
5. If you see "garbage" on the first line of the profile as it downloads then you should
redo the download. This could happen on some systems on the very first profile you
download during a session in Hyperterminal.
6. To download more profiles in the same session simply repeat step 3 from the point
you select "Transfer". After all profiles you wish to download have been transferred,
press GO on the 6300-M4. Check that the profile loaded properly by selecting
Function 4 on the 6300-M4 and entering the profile number starting at step 1 (i.e.
"18.1" to check profile 18). Step through the profile using only ENTER and check if
the points match what you have setup on the PC as your profile.

4.5 EXECUTING A PROFILE

On the 6300-M4, select Function 4: Execute profile. On line 4 on the Main screen, a profile
number is required to identify the profile. This number is x.y where x is the profile number
and y is the point number within that profile. Since a particular point can be specified, the
user can start a profile at any point, not necessarily at point 1. 'x' can have a value between 1
and 20 and 'y' can have a value between 1 and 50.
When a profile number is entered using the ENTER key, the name of the profile will appear to
the right of the profile number and the parameters of the particular point in that profile will
be displayed on the screen in their respective locations. It will appear as if the user had
entered all those parameters from the front panel. The value x.y will flash on line 4 of the
display, indicating that the point is ready to be executed. To execute the point press 'GO'. To
view the next point in the profile press 'ENTER'. As long as the profile point number is
flashing, it will not be executed.
Some of the rules to follow and points to observe while executing profiles are:
1. Press CANCEL to abort a profile. If CANCEL is pressed while the system is moving
towards a target value, it will continue to do so. Aborting a profile simply allows the user the
freedom to perform all functions possible from the front panel with no restrictions. Operating
within a profile restricts the user to follow the profile.
40